Gay-Lussac’s Law with a Go Direct Pressure Sensor

Introduction
The primary objective of this experiment is to determine the relationship between the Pressure and Temperature of a confined gas. The gas we use will be air, and it will be confined in the Conical Flask, this means we have a fixed Volume and fixed gas mass. This pressure change will be monitored using the Gas Pressure Sensor and the temperature will be monitored by a Temperature sensor. Pressure and Temperature data will be collected during this experiment and then analyzed. From the data and graph, you should be able to determine what kind of mathematical relationship exists between Pressure and Temperature. Historically, this relationship was discovered by Joseph Louis Gay Lussac in 1802 and has since been known as Gay-Lussac’s law. It is also referred to Pressure-Temperature Law.
Techniques/skills covered
- use ICT such as computer modelling, or data logger with a variety of sensors to collect data, or use of software to process data
Equation
P1/T1=P2/T2
P/T= Constant
T1 and T2 in Kelvins (K) P can be any pressure unit.
Objectives
In this experiment, you will
- Use a Gas Pressure Sensor and Temperature Sensor
- Determine the relationship between pressure and Temperature of the gas.
- Describe the relationship between gas pressure and Temperature in a mathematical equation.
Method
On the Go Direct® Gas Pressure Sensor and Go Direct Temperature, press the power button once. The LED will blink red. Launch the Graphical Analysis App. Click Sensor Data Collection. Now select GDX-GP in the list (if you have more than one device, select the serial number corresponding to that on the case). The LED on the connected sensor(s) will now blink Green. Now select the GDX-TMP in the list (if you have more than one device, select the serial number corresponding to that on the case). The LED on the connected sensor(s) will now blink Green. Click DONE.
Data Collection settings
Select mode from the bottom left of the screen and change the settings to
Mode: Time based
Time Units:
Rate:
Duraiton:
Data Collection
Pour the hot water into the beaker so it is covering the neck of the conical flask.
Monitor the live temperasture readout unilt it stops increasing. Once it has stablised its time to collect some data.
First select Collect from the top of the graph screen to being the data collection.
Analysis
** add bits here to chaneg and vcalcto absoltue zero
Tap Display setting in the top right corner, select 1 graph
Tap Graph Options from the bottom left corner. The select Apply Curve Fit, select Linear.