An Extensive range of transducers, sensors and signal conditioners can be connected to any measuring input on virtually any ALMEMO® instrument, thanks to the patented ALMEMO® connector. All the Sensor data is stored in this connector, and once its connected to an ALMEMO® instrument the instrument is loads this data and configures itself.

When the ALMEMO® sensor is connected the Instrument automatically loads the sensor Data from the EEPROM chip on the ALMEMO® connector. This includes the Measurement range, Measurement units and the Measured value.

With over 60 standard measurement ranges available you have the flexibly to measure so many different variables at the same time

Custom Calibrations can be programmed on the ALMEMO® Connector to give greater accuracy measurements. This programming is done via out free ALMEMO® Control Software.

With the ALMEMO® System you can switch between sensors without having to manually reprogram the Display instrument, reducing the amount of instruments you have to carry around.

For existing or third-party sensors we can provide an ALMEMO^® Connector that will allow you to connect to your ALMEMO^® instrument

On selected measuring ranges. Using an ALMEMO^® KL instrument it is possible to program a 30 point linearisation and correction via a PC. This is then saved onto the ALMEMO^® connector.  This mulitpoint programming can be read by ALMEMO^® Measuring instruments.